The SimRush Pro WiFi is an indoor controller / router for your network. This model can support up to 2 Outdoor units
It is pre-configured out of the box and managed through the SimRush web portal SPanel. To get online, simply plug in your SimRush Outdoor unit (ODU) as instructed below.
ℹ️ The ODU 5G requires the controller to be powered with a 48v Source to pass power to the 5G unit on port 10.
Instructions:
Make sure you follow the following steps to get online.
- Connect the ethernet cable to Ethernet Port 10 for ODU1, Ethernet Port 9 for ODU2 (far right ports – Highlighted in GREEN) – Please note that Port 9 requires the supplied PoE injector.
- Connect the Controller to the power adaptor supplied (24v 2.5a DC)
- Connect your PC to the LAN (Highlighted in ORANGE )
- Ethernet port 2-8 and SFP
- Wireless – Default wireless is “SimRush-xxxxxx” and the Serial number as the password, e.g AABBCC112233 – Serial number is located on the box or back of the controller, all characters before the “/123”
- To make changes to the LAN address or Wireless settings, please visit SPanel:
5. (OPTIONAL) Connect your alternative broadband to utilise the built-in Load-Balancing feature, connect Ethernet Port1 ( Highlighted in RED ) to your alternative broadband network.
ℹ️ Please ensure your alternative broadband router is providing the following network via DHCP:
Gateway: 192.168.1.1 , Subnet: 255.255.255.0
Cable guide
Outdoor unit may vary from that of image, but the port to connect the ethernet cable in remains the same.
| SimRush Pro WiFi | |
|---|---|
| Ether1 | AUX1 |
| Ether2 | LAN |
| Ether3 | LAN |
| Ether4 | LAN |
| Ether5 | LAN |
| Ether6 | LAN |
| Ether7 | LAN |
| Ether8 | LAN |
| Ether9 | ODU2 |
| Ether10 | ODU1 |
| SFP-SFPPlus-1 | LAN |
| PSU | 24v 2.5a |
